A SERVICE OF

logo

Open as PDF
next previous
88 Chapter 4
Test Controller
User interface
• 5=Read All Test Parameters—Reads all 128 words that make up the
test parameter set and displays this information. These test
parameters reside in NVRAM and are defined by the particular test.
An example of the display is shown in the example below:
Test Configuration menu - Test Parameters
Test Configuration Menu - Test Parameters
WordValueWordValue
00xhhhhhhhh100xhhhhhhhh
10xhhhhhhhh110xhhhhhhhh
20xhhhhhhhh120xhhhhhhhh
30xhhhhhhhh130xhhhhhhhh
40xhhhhhhhh140xhhhhhhhh
50xhhhhhhhh150xhhhhhhhh
60xhhhhhhhh160xhhhhhhhh
70xhhhhhhhh170xhhhhhhhh
80xhhhhhhhh180xhhhhhhhh
90xhhhhhhhh190xhhhhhhhh
• 6=Read One Test Parameter—Allows the user to read a single test
parameter.
• 7=Write Test Parameter—Allows the user to modify any one of the
test parameter words. The user is first requested to specify which
word is to be modified:
Specify Test Parameter word [0-127]:
After specifying the word, the user is then prompted for the new
value:
New value for Test Parameter word xx:
• 8=Reset Parameters—Resets some of the parameters to their default
values. Table 21 lists the affected parameters and their default
values.