Chapter 3 73
Power-On Self Test
Messages
Contiguous memory block not found
This message indicates that POST could not find a block of contiguous
memory to place at address zero to achieve good memory. POST will
report no main memory to the OBP for this failure.
For example:
HP/UX good memory region could not be achieved.
Processor not reported
This message indicates that a processor failed to mark itself in the
system report register. Reporting happens early in the sequence, and
this failure usually indicates the processor has failed to execute any
instructions.
For example:
Failed probe of PB1R_B, CPU failed to report in.
Processor initialization/selftest failure
This message indicates that a processor failed at some point during
initialization or selftest. The chassis code for the module that failed is
reported.
For example:
Failed probe of PB1R_B
chassis code 0x6103C
Processor not responding to interrupt
This message indicates that a processor properly initialized itself but did
not respond to an external interrupt
For example:
Failed probe of PB1R_B
cpu PB1R_B did not respond to an interrupt
Shared Runway bus failure
This message indicates that an available processor has been
deconfigured because it shares a Runway bus with a processor that failed
to probe
