A SERVICE OF

logo

Open as PDF
next previous
Chapter 3 59
Power-On Self Test
Interactive mode
Configuration parameters
The following parameters control the runtime operation of POST:
• ts_ip—Specifies the teststation IP address for LAN messaging. The
value should be set to the IP address of the diagnostics LAN port on
the teststation. [default: 15.99.111.99]
Table 7 Name of teststation IP address for listed utilities
• scub_ip—Specifies the IP address used for LAN interface hardware
on the utilities (SCUB) board. This is the IP address that POST, OBP,
and the Test Controller use for LAN messaging with the teststation.
[default: none]
Table 8 Name of scub IP address for listed utilities
• cti_cache_size—Specifies the amount of memory, in megabytes,
to reserve in the node for CTI cache. This is used only in multinode
configurations. [default: 0 Mbytes]
Utility Parameter name
OBP ts-ip#
POST ts_ip
sppdsh ts_ip
Utility Parameter name
OBP obp-ip#
POST scub-ip
sppdsh scub_ip
ts_config scub_ip