92 Chapter 4
Test Controller
User interface
Pause at Test Start (0=disabled, 1=enabled):
• F=Pause at Test End—Allows the user to modify the pause at test end
flag. This flag results in the Test Controller pausing the testing on
this processor after last subtest has completed execution and all
cleanup is complete. The user is prompted for the new value as
follows:
Pause at Test End (0=disabled, 1=enabled):
• G=Pause at Subtest Start—Allows the user to modify the pause at
subtest start flag. This flag results in the Test Controller pausing the
testing on this processor just prior to starting the execution of the
current subtest. The user is prompted for the new value as follows:
Pause at Subtest Start (0=disabled, 1=enabled):
• H=Pause at Subtest End—Allows the user to modify the pause at
subtest end flag. This flag results in the Test Controller pausing the
testing on this processor just after detecting that the current subtest
has completed execution. The user is prompted for the new value as
follows:
Pause at Subtest End (0=disabled, 1=enabled):
• I=Pause on Failure—Allows the user to specify whether testing
should halt when the specified number of failures is detected. The
default is to halt. The user is prompted for the new value as follows:
Pause in Failure (0=disabled, 1=enabled)
