70 Chapter 3
Power-On Self Test
Messages
the checksum and was rebuilt to the default structure.
For example:
Test Station Parameters checksum FAILED, rebuilding...
This node may be forced with the sppdsh reboot <node> default
command
Configuration map failure
This message indicates that the configuration map structure failed the
checksum and was rebuilt to defaults. Any user deconfigured hardware
state is lost.
For example:
Configuration Map checksum FAILED, rebuilding...
Configuration map failure
This message indicates that the configuration parameters structure
failed the checksum and was rebuilt to the default structure. Any user
overrides from the default value, for parameters that have a default, is
lost. Some parameters have no default and retain the value in NVRAM.
Since NVRAM could be corrupt, these values could be invalid.
For example:
Configuration Parameters checksum FAILED, rebuilding...
ASIC probe failure
This message indicates that the specified ASIC failed the probe. The
status of any components that must be accessed through this component
are unknown, and they are be available if installed.
For example:
Failed probe of P1R.
Unable to determine status of PB1R_A PB1L_A PB1L_B
PB1L_A IOLR_B.
