Filter
Top Products
102AdvAnced Functions
module. The Function button and Enter/Cancel LEDs will flash. Press the
C h an n E l 9 aC t i vE button; a unique LED pattern flashes to warn the user that
the network is about to be locked. Key in the four‑number network password
using the channel Active buttons. Press En t E r to complete the operation. A
special forward sweeping LED sequence is displayed in the channel meters
to confirm that the network is being locked.
Press Ca n C E l to exit without locking the network.
The network will be locked until the network password is provided. The Ed i t
lo C k button will light to indicate that the network is locked.
Password Unlock
When a Pro64 network is password protected, a specific four‑number
password code is required to unlock it. The network can be unlocked only at
the Control Master.
To unlock the network, press the Fu n C t i o n button on the Control Master
module. The Function button and Enter/Cancel LEDs flash. Press the C h an n E l
9 aC ti v E button. Key in the four‑number network password using the channel
Active buttons and then press the En t E r button. The channel level meters
display the reverse of the password lock LED sequence to confirm that the
network is now unlocked. Pro64 modules can be edited or reconfigured as
needed.
To exit the unlock request without unlocking the network, press Ca n C E l to
exit.
Set a New Password
Each Pro64 module can store a four‑number network password. However,
the password lock/unlock feature can only be used from the network Control
Master. Passwords can be changed only when the network is unlocked.
The password is a four‑number sequence created using the numbered
channel activation buttons 1‑16 on the front panel. Passwords can include
repeated numbers (such as the default factory‑supplied password of 1‑1‑1‑1).
When creating a password, any string of numbers can be used, but note that
only the last four button presses are stored.
To set a new password, press Fu n C t i o n and then the C ha n n E l 10 aC t iv E button.
Key in a four‑number button sequence and then press En t E r . The channel
buttons flash to indicate that the new password has been set. Pressing the
Ca n CE l button will exit the function and leave the original password intact.