Filter
Top Products
36ne two rk settings
Network Mode
The LEDs in the A‑Net Transmit section show information about the current
network mode, which can be set to Auto Mode or Manual Mode only at the
network’s Control Master. When the Pro64 network is operating in Auto
Mode, the red Auto LED will be lit on all modules, and no user settings are
available on a per‑module basis. When using Auto Mode, it does not matter
which rear‑panel A‑Net port (A or B) is used when connecting I/O devices to
the network.
A-Net Transmit
The A‑Net Transmit section of the 6416m interface is used when the network
is in Manual Mode. In Manual Mode, the red Manual LED will be lit and user
can direct the active channels from the 6416m to a specific rear‑panel A‑Net
port.
6 416
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
Use the selection button to choose a Transmit Port when operating the
network in Manual Mode.
In Manual Mode, the user has the option of directing A‑Net data to either
or both A‑Net ports on the rear of the 6416m Mic Input Module. Once the
Control Master has set the network to operate in Manual Mode, the red
Manual LED and at least one of the yellow Port LEDs will be lit on every Pro64
I/O module.
Three options are available:
Po r t a• ‑ the 6416m transmits data from its active channels
only out of port A on the rear panel
Po r t B• ‑ the 6416m transmits data from active channels
only out of port B
•Po r t a a n d B ‑ (both LEDs are lit) the 6416m transmits
its active channels out of both the A and B ports.