Filter
Top Products
70rci Front PAnel FeAtures
CONTROL
CONTROLLER
A-NET SLOT
HEADPHONES
Group 2
Group 4Group 3
Port A
Port B
Sync
Auto and Manual Mode LEDs and Port selection options on the RCI
A-Net Slot
The A‑Net Slot display shows the network Slot that is currently available to
be monitored by the headphone and rear‑panel XLR outputs. Any active
network Slot can be monitored, even if its content is not coming from a
microphone input module.
The display will scroll sequentially through all available Slots (as determined
by the current network sample rate) with two variations: double dashes with
and without the Sync dot on.
The display will show a double dash (––) when no Slot is selected. No audio is
monitored at the headphone and XLR outputs in this case.
The display will show a double dash with a dot (––.) to indicate that the RCI
Slot to be monitored is selected remotely from the MCS Mic Control Surface.
The display will reflect the Slot being monitored plus the dot when Slots are
selected from the MCS. The RCI and MCS will remain in sync until the user
selects a channel directly from the RCI front panel.
Inc/Dec Slot Selection
Use the inc/dec button below the numeric Slot display to select an active
Slot to be monitored.
Selecting a Slot directly from the front panel of the RCI while the RCI and
MCS are in sync causes the synced operation to stop.
CONTROL
CONTROLLER
A-NET SLOT
HEADPHONES
Group 2
Group 4Group 3
Port A
Port B
Sync
A-Net Slot selection and sync indication