Filter
Top Products
26control MAster
6 416
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
The selection button in the A-Net Transmit section of the interface is used to
choose Manual Mode options.
Changing the Network Mode
The button beneath the Auto/Manual Mode LEDs is used to select the
network mode and to set the transmit port in Manual Mode. Pressing the
selection button will cycle through the available settings and will flash both
the mode LED and the Enter/Cancel LED. To confirm and change the network
mode, press the En t E r button. The Control Master will update the display on
all modules in the network to reflect the change. Press the Ca n C E l button to
exit the mode change and return to the current state.
Managed Mode
Managed Mode requires the use of a computer with the Pro64 network for
tasks such as firmware updates, system monitoring, control, and editing.
The Control Master is the only module that can allow the network to enter
Managed Mode.
Entering Managed Mode requires the user to press the En t E r button after
pressing the Ma n a g E d button on the Control Master. Once the network
enters Managed Mode, all modules will light their Managed LEDs.