Filter
Top Products
416416M Front PAnel
Clock Master
Every Pro64 network will have one Clock Master. The module designated as
Control Master will have its yellow Clock Master LED, found above the sample
rate section, lit. In a network that uses all analog modules, setting the 6416m
to be the network Control Master automatically assigns it to be the Clock
Master. See page 33 for more info.
6 416
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
The Clock Master LED above the Sample Rate display will light when the
6416m is the network’s Clock Master.
Sample Rate
The Sample Rate display will show the current network sample rate. If the
6416m is Control Master and Clock Master, changes to the current sample
rate can be made from the front panel of the device.
The selection button below the Sample Rate LEDs is used to choose a sample
rate (requires the use of the Enter button).
Function Button
The Function button located below the Sample Rate LEDs is used to access
the Advanced Functions, described in detail later in this document (see page
97).
Control Master LED
The red Control Master LED lights to indicate that a Pro64 module has been
set to be the network Control Master. Only one module can function as
Control Master at a time.