Filter
Top Products
85Mcs FeAtures
No
Control
The high resolution meter and Peak Hold button
Peak Hold Button
When on, the Peak Hold function will show and hold the highest level
(including any clips) that has occurred on the high‑res meter as well as any
clips that may have occurred on active Slots (displayed using the 64 bicolor
LEDs). To use the Peak Hold function, press the PE ak ho l d button once; its
LED will light.
Press the PE a k ho l d button again to clear the last displayed peaks and turn
the hold function off.
Controller Connector
The rear panel of the MCS contains an EtherCon® connector for connecting
the MCS to an RCI Remote Control Interface. The cable connected to this port
supplies data and DC power for the MCS.
Cables Connecting the MCS and RCI
Use any standard Cat‑5e UTP (or better) cable to connect the MCS to the RCI.
Cable length can be up to 400 feet (120 meters).
Avoid damage to the product. Do not plug the MCS Mic Control Surface
into anything other than the RCI Remote Control Interface front-panel
control port.