Filter
Top Products
526416M Front PAnel
When phantom power is enabled, the selected channel strip’s +48V LED will
be lit. The on/off state of the +48V phantom power is saved for every channel
in each mic pre Preset.
Phantom power on/off can also be controlled from a Yamaha device when
using m‑control.
Channel Gain
Each input channel on the 6416m has an individual gain setting controlled by
the Gain knob. Press Ed i t to select a channel for editing and then rotate the
ga i n knob to the desired setting. When the RCI/MCS is part of the network,
gain changes can be made from the front panel or the remote controller.
Gain is set in 1dB steps and has a range of 0‑55dB. Channel gain can be
controlled from a Yamaha device using m‑control when a 6416Y2 A‑Net
Interface Card is installed.
Each channel’s gain setting is saved as part of a mic preamp Preset.
Gain Display
The two‑digit gain display shows the level for the currently selected mic
preamp channel.
6 41 6
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
The selected channel’s gain is displayed and can be edited. In this diagram
channel 16 is selected for editing.
Control Group
Each 6416m mic module in a Pro64 network can be set to one of four Control
Groups. This allows multiple zones of mics and preamps to be remote
controlled by different users if desired by adding the optional RCI Remote
Control Interface and MCS Mic Control Surface.