Filter
Top Products
25control MAster
6 416
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
Press the selection button to cycle through the available sample rates.
The current sample rate for the network will be displayed on all I/O modules
in the network. Only one sample rate can be used at a time.
Changing the Sample Rate
To set or change a network‑wide sample rate from the Clock Master, use the
button below the Sample Rate LEDs to select a new rate. Pressing the Sample
Rate selector button will cycle through all available sample rates, flashing
the value for the new rate. At the same time, the LED between the Enter and
Cancel buttons will flash, indicating that pressing one of these buttons is
required to confirm and complete (or cancel) the operation.
Changing the sample rate will affect the number of available A‑Net Slots
when the sample rate changes from the 1x range (44.1/48kHz), to the 2x
range (88.2/96kHz), to the 4x range (176.4/192kHz) or vice versa.
Note that Yamaha devices are not compatible with sample rates above 96kHz
when a 6416Y2 card is included in a Pro64 network.
Auto/Manual Mode Selection
The Control Master can be used to set the current network mode for the
system to Auto or Manual. As with the system‑wide sample rate, the network
mode is also a global setting.
The network mode selection controls are in the same part of the user
interface as the A‑Net Slot selection.