Filter
Top Products
486416M Front PAnel
To link a pair of channels, both channels must be active on the network
first; the Active button located below the Edit button must be lit on both
channels. Once the two channels are active, pressing the li n k button will link
the two channels immediately; no confirmation is required.
Attempting to link channels that do not meet the requirements above will
cause the Link button and one or more channel button LEDs to flash to
indicate the error.
6 416
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
To link a pair of channels, both channels must be active rst.
Linked channels will be displayed on all Pro64 output modules. Link
information can be used by Pro16 output devices such as the A‑16II and A‑16R
Personal Mixers. Add the ASI A‑Net Systems Interface to a Pro64 network in
order to make use of Pro16 output devices.
Mute Button
Use the Mute button to silence an active mic preamp channel while leaving
it active in the network. Press the Mu t E button once to activate the mute
function; press Mu t E again to release the channel from the muted state.
Each channel’s Mute state is saved as part of a mic pre Preset.