Filter
Top Products
516416M Front PAnel
Ca n CE l to exit without turning the Pad off.
When the 24dB pad is in use, the Pad LED in the selected channel strip will
be lit. When using m‑control to control the 6416m from a Yamaha device,
the 6416m Pad will turn on/off automatically in response to gain change
messages from the Yamaha device.
Mic pre Presets save the Pad state for each channel.
+48V Phantom Power Button
Phantom power for devices such as condenser mics is available for each mic
preamp channel. Turning the +48V phantom power on or off for a channel
requires use of the Enter button.
Avoid potential damage to your hearing or audio equipment by muting the
mic channel first if you are unsure about the use of phantom power.
To turn phantom power on, press the +48v button once. The Enter and
Cancel LEDs will blink. Press En t E r ; the phantom power is on. Press the Ca n CE l
button to exit without turning phantom power on.
To turn a channel’s phantom power off when it is enabled, press the +48v
button. The Enter and Cancel LEDs will blink. Press En t E r ; the phantom
power is turned off. Press Ca n C E l to exit without turning the +48V phantom
power off.
6 41 6
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain (dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Link
Link Link
Link
Link Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48VPhase Low CutSAVE RECALL Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute Mute Mute
Mute
Edit Edit Edit Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
Channels 14 and 15 in this diagram are shown with the phantom power
activated. Channel 15 is selected for editing.