Filter
Top Products
21
Continue this process of setting volume and pan until all the Channels
have been added to the mix.
At this point you should have a basic mix playing in your monitor
device. You can continue to make changes in real time as your needs
require. Remember that changes to Channel volume and pan setting
affect the selected Channel only. The selected Channel always has its
red LED lit.
Saving Your New Preset
It’s important to remember that your mix is not saved if you should
power the system down unless you store the mix as a Preset. You
need to save a Preset to a memory location to be able to recall it later.
The Channel buttons serve as memory location buttons when in Save
mode.
To save a Preset:
• Hold down the R
ECALL and GROUP buttons, found to
the left of the label strip on the A-16R and in the upper
left side of the A-16CS.
• While still holding the RECALL and GROUP buttons,
press the Channel button (1 through 16) corresponding
to the memory location where you want the mix to be
stored.
• Release the Channel button to store a Preset; you will
see all the Channel LEDs flash in sequence as confir-
mation of the save
operation.
• Release the R
ECALL and GROUP buttons after selecting
a location.
If you want to store the same mix to multiple memory locations, you
can press memory location buttons as needed while the R
ECALL and
GROUP buttons are being held down. A copy of the mix will be saved
to each memory location.
What Gets Saved
When you save a Preset the following information is saved:
• Channel volumes
• Channel pan settings
• The Mute status of all Channels
• Channel Groups (up to three) and Group volume
settings