Filter
Top Products
33
To use Held Solo Mode:
• Press and hold the S
OLO button.
• While holding down the S
OLO button, press and then
release any Channel button.
• You can now release the S
OLO button. (If you release
the SOLO button before releasing the Channel button,
Held Solo Mode will not be engaged.)
• The Channel that you pressed is now soloed, and the
Solo LED is flashing.
• To solo another Channel, press any Channel button.
• To exit Held Solo Mode, press the S
OLO button again.
You can also exit Held Solo Mode by pressing the R
ECALL, GROUP, or
MUTE buttons.
Remember that the system can only enter Held Solo Mode from the
normal Mix Mode. If you currently have a Channel temporarily soloed
(the Solo LED is lit solid), you must exit the temporary Solo Mode (by
hitting another Channel button or the SOLO button) before you can
enter Held Solo Mode.
Note: The status of Solo Mode is not saved with a Preset.
Muting a Channel
While creating a mix, any Channel or combination of Channels can be
muted. Unlike the Solo Mode, the changes you make with the MUTE
button can be saved as part of a Preset.
To mute a Channel:
• Select the Channel first
• Press the M
UTE button
• The yellow LED in the Channel button lights
To unmute a Channel:
• Select a muted Channel
• Press the M
UTE button
• The yellow LED in the Channel button will go out
Additional Channels can be muted or unmuted by following the same
procedure—first select the Channel, then press the M
UTE button.