Filter
Top Products
62
Aviom A-16R and A-16CS User Guide
Troubleshooting
Before contacting Customer Service, check the following list of
common problems and solutions for help.
Problem: No audio from the Personal Mixer outputs
Possible Solutions:
• No input audio from the main mixing console. Check
the levels of the main mixing board that the system is
connected to.
• Check the cables and connections between the main
mixer and the A-Net system’s input module. The Signal
LEDs on the front of the A-Net input modules can be
used to confirm that audio is being received.
• Bad cables; try a replacement.
• All Channels on the Personal Mixer are at zero.
• Master Volume level on the A-16R Personal Mixer is at
zero.
• A-Net cables are not connected properly.
Problem: Can’t change Presets
Possible Solutions:
• Make sure that the R
ECALL button has been pressed.
Its LED will flash, indicating that you should press a
numbered button to recall a Preset.
• When using the A-16CS with the A-16R, check the
position of the REMOTE/LOCAL switch.
Problem: Can’t hear a Channel that is part of a Group
Possible Solutions:
• The Group might be muted. Check the lower (yellow)
LED in the Channel buttons. A lit yellow LED indicates
the Channel is muted. To unmute it, press the M
UTE
button while the Group is selected. The yellow LED
must be unlit in order to hear the audio on that channel.
• The Channel volume is all the way down. In Group
edit mode, select the Channel and check the level for
that Channel by looking at the LEDs in the Volume
indicator. If no LEDs are lit, then the Channel is turned
all the way down. Raise the volume by turning the
Channel V
OLUME knob; re-save the Group and Preset if