10
Front and rear panel
fig.front
4. Input/output level indicators
These LEDs light according to the level of the signals that are being input via the combo
input jacks (1)
and
WAVE OUT 1/2 (in the case of WDM,
OUTPUT 1
➔
see p. 22). (see block diagram
➔
front cover)
To adjust the input level, stop playback of the sound from your computer.
5. Sync indicator
When the
digital input switch (6)
is on, this indicator shows the status of synchronization with a digital
device connected to the
digital input connector (7)
. (external synchronization mode)
6. Digital input switch
If you want to record a digital input, turn this on ( pressed inward). This lets the FA-101 synchronize to an
external digital device connected to the
digital input connector (7)
.
7. Digital input connector (optical)
Use this when you want to input a digital audio signal from a CD/MD/DAT or similar device.
The signal input to the digital input connector is input as
INPUT 9
and
10
(in the case of WDM,
INPUT 5
➔
see p. 22).
If you want to record this digital input signal, turn on the
digital input switch (6)
.
You must input a signal of the same sampling frequency as that selected by the
sample rate select switch
(9)
.
8. Digital output connector (optical)
Use this when you want to digitally connect an audio device, such as an MD or DAT unit.
The digital signal sent from the
digital output connector
is output as
OUTPUT 9
and
10
(in the case of
WDM,
OUTPUT 5
➔
see p. 22).
When functioning as input
level indicators
The red LED will light if the sound distorts. Use the
input level
knobs (2)
to adjust the input level so that the red LED does not
light.
When functioning as output
level indicators
The red LED will light, but the sound is not distorting.
* When operating at 192 kHz, the indicator will light only for input;
it will not light for output.
Lit green
Synchronized correctly.
Blinking green
Not synchronized. Check that your digital device is correctly connected to the
digital input connector.
Also make sure that the connected digital device is set to the same sampling fre-
quency as that selected by the FA-101’s
sample rate select switch (9)
.
1
2
4
4
78 9
56
10 11
15
12
13
14
3
16
FA-101_e.book 10 ページ 2005年11月24日 木曜日 午後1時25分