Edirol FA-101 Musical Instrument User Manual


 
28
Basic connections and settings
fig.digital
Connections
Connect your digital device to the digital input connector.
Sample rate select switch
Set this to match the sample rate of your digital playback device and the sample rate of your recording software.
If you switch the FA-101's sample rate, you must turn the power of the FA-101 off, then on again to get the
setting to take effect.
You cannot record digital signals if the 192 kHz setting is selected.
Digital input switch
Turn this on (lit) so that the FA-101 will synchronize to the digital signal being input to the digital input
connector.
When synchronized correctly, the sync indicator will light green. If this indicator is blinking green,
synchronization has not been achieved. In this case, check that the sample rate of the connected digital device
matches the sample rate selected by the FA-101’s sample rate switch.
Direct monitor volume
This adjusts the monitor volume.
Adjusting the direct monitor volume will not affect the recording level.
Recording a digital signal
Specify the sample rate
Set this to match the sample rate of
your digital playback device
ON
CD/MD/DAT player,
hard disk recorder, etc.
FA-101_e.book 28 ページ 2005年11月24日 木曜日 午後1時25分