Filter
Top Products
46
Main Specifications
●
Number of Audio Record/
Playback Channels
<44.1/48/88.2/96 kHz> (Full duplex)
Record: 10 channels
Playback: 10 channels
<192 kHz> (Full duplex)
Record: 6 channels
Playback: 6 channels
* Some computers may not have sufficient performance.
●
Signal Processing
PC interface: 24 bits
AD/DA Conversion: 24 bits (linear)
●
Sampling Frequency
Digital output: 44.1/48/88.2/96 kHz
Digital input: 44.1/48/88.2/96 kHz
AD/DA Conversion: 44.1/48/88.2/96/192 kHz
●
Frequency Response
96.0 kHz : 20 Hz to 40 kHz (+0/-2 dB)
88.2 kHz : 20 Hz to 40 kHz (+0/-2 dB)
48.0 kHz : 20 Hz to 22 kHz (+0/-2 dB)
44.1 kHz : 20 Hz to 20 kHz (+0/-2 dB)
●
Nominal Input Level
Input Jack 1–2 (XLR type)
-50 to -10 dBu
Input Jack 1–2 (1/4 inch TRS phone type)
-35 to +4 dBu
Input Jack 3–6
+4 dBu (balanced)
Input Jack 7–8
-10 dBu to +4dBu(balanced)
●
Nominal Output Level
Output Jack 1–8
+4 dBu (balanced)
●
Residual Noise Level
(input terminated with 1 k ohms,
MAIN VOLUME: 0 dB,
INPUT SENS: +4 dBu,
DIRECT MONITOR VOLUME: OUT1/2 position,
IHF-A typ., Balanced)
Output Jack 1–2
98 dBu
●
SN RATIO (Typical)
OUTPUT: 108 dB (typ.)
INPUT: 102 dB (typ.)
●
Interface
Firewire (IEEE1394)
Digital input/output
Optical type (conforms to IEC60958)
MIDI IN/OUT
●
Connectors
<Front Panel>
Input Jack 1–2 (XLR type / 1/4 inch TRS phone type)
XLR type (balanced / phantom power +48V)
1/4 inch TRS phone type (balanced)
* INPUT2 jack: high impedance is supported
Digital In Connector (Optical type)
Digital Out Connector (Optical type)
Headphones Jack (Stereo 1/4 inch phone type)
<Rear Panel>
Input Jack 3–8
(1/4 inch TRS phone type (balanced))
Output Jack 1–8
(1/4 inch TRS phone type (balanced))
MIDI Connectors (In, Out)
FireWire (IEEE1394) Connectors
●
Power Supply
DC 9V (AC adaptor)
●
Current Draw
900 mA
●
Dimensions
218 (W) x 137 (D) x 46.5 (H) mm
8-5/8 (W) x 5-7/16 (D) x 1-7/8 (H) inches
●
Weight
0.95 kg / 2 lbs 2 oz
●
Accessories
Owner’s Manual
CD-ROM
AC Adatptor
FireWire (IEEE1394) cable (6 pins to 6 pins)
FireWire (IEEE1394) cable (6 pins to 4 pins)
(0 dBu = 0.775 V rms)
* In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice.
FA-101_e.book 46 ページ ２００５年１１月２４日 木曜日 午後１時２５分