Filter
Top Products
39
Troubleshooting
Are the volume controls of the FA-101 set appropriately?
Adjust the headphone volume knob and direct monitor volume of the FA-101’s front panel.
Is your audio playback system (e.g., stereo) connected correctly?
Make sure that the FA-101’s output jacks are correctly connected using audio cables to the input jacks of your
audio playback system. For details on connections, refer to
“Basic connections”
(p. 25).
Did you connect/disconnect the FireWire (IEEE 1394) cable or cycle the power to the FA-101
while your software was running?
You must close all software that uses the FA-101 before powering off the FA-101.
If you start up your computer with the FA-101 connected, operation may become unstable for some computers.
In this case, connect the FA-101 after starting up your computer.
Could your computer have entered Standby (Suspend) or Sleep mode?
After your computer wakes up, close all software that had been using the FA-101, and then cycle the power to
the FA-101.
Have you specified the audio and MIDI data output destination in the operating system?
Depending on the software you are using, you may need to specify the FA-101 as the audio data output
destination for your computer. For details on this setting, refer to
“Driver settings”
(
➔
Macintosh, p. 14 /
Windows, p. 22).
Is the driver installed correctly?
In order to use the FA-101 to play back audio/MIDI data, the driver must be installed. For details on installation
and settings, refer to
“Installing the driver”
(
➔
Macintosh, p. 14 / Windows, p. 17).
Are you running numerous software programs?
An error message may appear if numerous software programs are running simultaneously. If this occurs, close
the software you are not using.
In Windows, a program is still running if it remains in the taskbar even after you close its window; close any
unneeded software shown in the taskbar.
Is the FA-101’s sample rate set to a rate other than 192 kHz?
If the FA-101’s
sample rate select switch
is set to 192 kHz,
output jacks 7–8
,
input jacks 7–8
, the
digital
output connector
, and the
digital input connector
are not available.
Are your input/output devices connected correctly?
In order to play back audio/MIDI using the FA-101, you must make the appropriate input/output device
settings. For details on making these settings, refer to
“Driver settings”
(
➔
Macintosh, p. 14 / Windows, p. 22).
If you are using the 192 kHz sample rate on Windows XP, the FA-101 may not appear in the
Sounds
tab of the
Sounds and Audio Devices
Properties dialog box. If so, please update your system to Windows XP Service
Pack 1.
Could the FA-101 have been connected when you started up the computer?
Start up the computer with the FA-101 disconnected, and then connect the FA-101.
Depending on the type of computer you are using, starting up the computer when the FA-101 is already
connected may cause operation to be unstable. In this case, start up your computer and then connect the FA-101.
No sound
Can’t record or play back audio or MIDI
No sound
FA-101_e.book 39 ページ ２００５年１１月２４日 木曜日 午後１時２５分