Filter
Top Products
14
Installing the driver (Macintosh)
1
With the FA-101 disconnected, start up your Macintosh.
2
Use a FireWire (IEEE 1394) cable to connect the FA-101 to your Macintosh.
1.
With the FA-101’s power switch off, connect the power cord to it.
2.
Plug the AC adaptor cable into an AC outlet.
3.
Use a FireWire (IEEE 1394) cable to connect the FA-101 to your Macintosh.
3
Turn on the FA-101’s
power switch
.
The driver will be installed automatically.
This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate normally.
Next, you need to make audio device and MIDI device settings.
(
➔
“Driver settings”
(p. 14))
If you want to use the FA-101 with the iTunes software included with your Macintosh,
specify the input/output devices as follows.
The procedure for making device settings differs depending on the software you are
using. For details, refer to the owner’s manual for your software.
1
From the
Apple
menu, choose the
System Preferences
dialog box, and click
Sound
.
2
Click the
Sound Effects
tab, and choose
EDIROL FA-101
for the
“Play alerts and
sound effects through”
setting.
3
Click the
Output
tab, and choose
EDIROL FA-101
for the
“Choose a device for
sound output”
setting.
4
If the
Input
tab is shown, choose
EDIROL FA-101
for the
“Choose a device for
sound output”
setting.
Driver settings
Input/output device settings
Once the connections have
b
een completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
If you want sound to be
played from the internal
speakers of your
Macintosh, choose
“Internal speakers” in the
Output tab. If you don’t
want alerts to be played
through the FA-101,
choose “Internal
speakers” for the “Play
alerts and sound effects
through” setting.
Cautions for use
Before you use your software with the FA-101, please note the following.
• Before you start up your software, use a FireWire (IEEE 1394) cable to connect the FA-101 with
your computer, and turn on the power.
• Do not disconnect the FA-101’s FireWire (IEEE 1394) cable or switch off the power to the FA-101
while your software is running.
• Close your software before you switch off the FA-101’s power.
• Turn off the Sleep setting of your Macintosh.
• The FA-101 will not work in the Classic environment of Mac OS X. Use it when the Classic
environment is not running.
• Turn off the energy conservation settings of your Macintosh.
• If the Options pane of the Energy Saver preferences on your Macintosh has a Processor
Performance setting, choose the “Highest” setting.
FA-101_e.book 14 ページ ２００５年１１月２４日 木曜日 午後１時２５分