Filter
Top Products
PROG P7: KARMA Initialize MOD SEQ
45
PROG P7: KARMA
Here you can make KARMA function settings for the
RADIAS program.
For details on the available parameters and menu
commands, please see “PROG P7: KARMA” on page 45 of
the M3 parameter guide.
PROG P8: IFX
Here you can make settings for the insert effects.
You can use insert effects for RADIAS programs in the same
way as for EDS programs.
For details on the available parameters and menu
commands, please see “PROG P8: IFX” on page 45 of the M3
parameter guide.
PROG P9: MFX/TFX
Here you can make settings for the master effects and total
effects.
You can use insert effects for RADIAS programs in the same
way as for EDS programs.
For details on the available parameters and menu
commands, please see “PROG P9: MFX/TFX” on page 45 of
the M3 parameter guide.
Menu Command
The menu commands explained here are those that are
displayed and available only if the EXB-RADIAS is
installed.
For details on the other commands, refer to the “M3
parameter guide.”
Initialize MOD SEQ
This command initializes the modulation sequence settings.
1. Choose “Initialize MOD SEQ” to access the dialog
box.
2. Select the modulation sequence that you want to
initialize.
All: All modulation sequences 1–3 will be initialized. The
following parameters will be initialized.
Last Step (Program 5–6(7)(8)a): 16
Sequence Type (Program 5–6(7)(8)a): Forward
Run Mode (Program 5–6(7)(8)a): Loop
KeySync (Program 5–6(7)(8)a): 1st Note
Resolution (Program 5–6(7)(8)a):
Destination Param (Program 5–6(7)(8)b): Pitch
Motion (Program 5–6(7)(8)b): Smooth
Step Value (Program 5–6(7)(8)b): 0
Single: One modulation sequence will be initialized. You
can specify the modulation sequence that you want to
initialize. The following parameters of the specified
modulation sequence will be initialized.
Destination Param (Program 5–6(7)(8)b): None
Motion (Program 5–6(7)(8)b): Smooth
Step Value (Program 5–6(7)(8)b): 0
3. Press the OK button to execute the initialization. If
you decide not to execute, press the Cancel button.