Filter
Top Products
27
padKONTROL Owner’s Manual
your changes will be lost. (p.15 “Saving a scene”)
■ Selecting the trigger pads and/or pedal that
will be enabled
For each trigger pad, you can independently specify whether
the Roll function will be enabled. You can also specify whether
the Roll function will be enabled for the pedal.
1 Hold down the [ROLL] key, and press the trigger pad and/
or [PEDAL] key that you want to use the roll effect on,
making the trigger pads or the [PEDAL] key light.
The Flam function will also be enabled for the trigger pads or
pedal for which the Roll function is enabled.
■ X-axis setting (roll speed)
1 Press the [NOTE/CC#/LEFT] key.
The [NOTE/CC#/LEFT] key will light, and the display will
indicate the value at the left edge of the X-Y pad (LEFT
value).
2 Use the encoder to specify the value for when the left edge
of the X-Y pad is pressed (LEFT value).
Lower values of this setting will produce a slower roll speed,
and higher values will produce a faster roll speed.
LEFT Value [40...240]
3 Press the [MIDI CH/RIGHT] key.
The [MIDI CH/RIGHT] key will light, and the display will
indicate the value at the right edge of the X-Y pad (RIGHT
value).
4 Use the encoder to specify the value for when the right
edge of the X-Y pad is pressed (RIGHT value).
Normally you will set this to a larger value than the LEFT
value.
RIGHT Value [40...240]
5 If you want to set another parameter, skip this step.
If you are done, press the [SETTING/ENTER] key.
The [SETTING/ENTER] key will go dark, and you will re-
turn to Play mode.
■ Y-axis setting (roll volume (velocity))
1 Press the [REL. VAL./LOWER] key.
The [REL. VAL./LOWER] key will light, and the display will
indicate the value at the lower edge of the X-Y pad
(LOWER value).
2 Use the encoder to specify the value for when the lower
edge of the X-Y pad is pressed (LOWER value).
Lower values of this setting will decrease the velocity, and
higher values will increase it.
LOWER Value [1...127]
3 Press the [VELOCITY/LOWER] key.
The [VELOCITY/UPPER] key will light, and the display will
indicate the value at upper edge of the X-Y pad (UPPER
value).
4 Use the encoder to specify the value for when the upper
edge of the X-Y pad is pressed (UPPER value).
Normally you will set this to a larger value than the LOWER
value.
UPPER Value [1...127]
5 If you want to set another parameter, skip this step.
If you are done, press the [SETTING/ENTER] key.
The [SETTING/ENTER] key will go dark, and you will re-
turn to Play mode.
Fixed Velocity setting
You can specify a fixed velocity value that will be used for all
trigger pads assigned to a note number and also as the veloc-
ity value for the pedal.
1 Press the [VELOCITY/UPPER] key.
This accesses the velocity setting. The [VELOCITY/UP-
PER] key will light.
2 Press the [FIXED VELOCITY/PRELOAD] key.
Fixed velocity will be enabled, and the fixed velocity value
will blink in the display.
3 Use the encoder to specify the fixed velocity value.
Fixed Velocity [1...127]
4 If you want to set another parameter, skip this step.
If you are done, press the [SETTING/ENTER] key.
The [SETTING/ENTER] key will go dark, and you will re-
turn to Play mode.
If the Roll or Flam function is on, this setting will not affect the
velocity of the second and subsequent strikes.