Filter
Top Products
20
X.200
Digital X Bus
58. SET
• To move the timeline cursor to a new position
in the Mix Editor, with LOCATE [57] lit, press
SET, then enter the time you want to move the
cursor to using the number buttons, then press
ENTER [49].
Transport Controls
These buttons control external devices that
respond to MIDI Machine Control (MMC). MMC is
transmitted from the MIDI OUT port on the rear pan-
el of the Digital X Bus to MMC-compatible devices.
Transport controls can be programmed to export
specifi c MIDI messages other than standard MMC
protocol. See MIDI Mapping for more details.
Note: MMC is not bidirectional. The Digital X
Bus sends out MMC commands to your tape
recorder(s), but if you arm tracks or operate trans-
port controls from the tape recorders, the activ-
ity is not transmitted back to the Digital X Bus
via MMC. You can, however, press Play on your
recorder and, as soon as time code is received, the
Digital X Bus reverts to PLAY mode.
59. REWIND
• Engages external machine and the time code
display to fast rewind.
60. FAST FWD
• Engages external machine and the time code
display to fast forward.
61. STOP
• Stops external machines and the time code
display at the current position.
62. PLAY
• Engages external machine and time code dis-
play to play at normal speed from the current
location.
63. RECORD
• Engages Master record function on external
machines.
• Must be pressed with PLAY to engage record
mode unless One Button Record is active. One
Button Record allows punching into record
mode without hitting PLAY (see Windows >
Setup > Mix Options).
64. SCRUB
• Engages the jog wheel to advance external ma-
chines forward or backward with single-frame
accuracy when using MMC.
REWIND FAST FWD PLAYSTOP RECORD
1 2
0
3
4 5 6
7 8 9
EDIT
START
END
SNAP
SHOT
LOCATE
SCRUB
STORE SET ENTER
ON
STOP
LOOP
START