Filter
Top Products
16
Parts and their functions
L
R
L
R
L
R
L
R
1
2
3
4
L
R
AUDIO IN
AUDIO OUT 1
1
Analog audio 1 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
1
2
Analog audio 2 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
3
Analog audio 3 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
4
5
Analog audio 4 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
Analog audio output connectors
2
3 4 5
EDITOR interface connector (9-pin)
This connector is used to connect the unit with an RS-
422A or RS-232C controller.
1
2
RS-422A/RS-232C selector switch
This is used to switch between the RS-422A and RS-
232C control protocols.
4
TALLY output connector
The rear panel tally is for the cross point 1, 2, 3, 4, 5, 6, 7
or 8 output.
The connector used by the cross point is turned ON.
Example of tally connections
3
SIGNAL GND (ground) terminal
5
AC IN power socket
RS422
RS232C
SIGNAL
GND
~AC IN
O
1
2
R
TALLY
EDITOR
AUDIO OUT 1
1
4
2
5
3
AG-MX70
GND
TALLY
output
Tally LED
(Max. current: 50 mA)
(Max. voltage: 3.5V)