Filter
Top Products
33
≥ When [Trail] has been set
Set the trail color and spark using the rotary 3 control.
Select the [Self] original image, [Self-spark], [BodM]
border color or [BodM-spark] border spark.
The time can be set to any value from 1 to 32 using the
rotary 4 control.
When trail has been set, the trail offset position can be set
by setting the position while holding down [Shift]. In this
case, the center, scene grabber and hold buttons flash
temporarily. Whichever trail or shadow effect was
selected last among trail and shadow for DSK, and multi
strobe and decay for A/B videoEffects takes effect, and
the previous effect is canceled.
<Note>
Only one of three settings—namely, soft, border or soft border—for both multi strobe and pattern edges can be selected
when a special pattern has been selected. For further details, refer to the note on page 26.
Effects
Trail
Time
16
Light
On
Lights
when 3D
board has
been
installed.
Self
Self-spark
BodM
BodM-spark
1 - 32
Self
Effects
Off
Light
On
Off
Shadow
Trail
Lights
when 3D
board has
been
installed.
Effects
Shadow
Light
On
Lights
when 3D
board has
been
installed.
[Effects] setting
This is used to perform the DVE settings.
Select the [Off], [Shadow] or [Trail] effect using the rotary 2
control.
Set the [Light] (lighting) using the rotary 5 control. This is
valid only when the 3D optional board (AG-VE70) has been
installed for use.
≥ When [Shadow] has been set
When [Shadow] has been selected, the shadow position
can be set by setting the position while holding down
[Shift].
In this case, the center, scene grabber and hold buttons
flash temporarily.
R1 R2 R3 R4 R5
R1 R2 R3 R4 R5
R1 R2 R3 R4 R5
Effect-by-effect setting screens