58
Other settings
Setting method
One hundred panel statuses can be stored in event
memories 0 to 99. Press the Set button, set the event
number using the number keys, and enter the setting using
[Enter].
Event memory
Event
00E
Press the [Pattern] button, input the pattern number using
the number keys, and execute using [Enter]. If the pattern
does not exist, operation will jump to the nearest pattern
number.
Each time [Pattern] is pressed, the function is set to ON or
OFF. The default setting is MIX (56).
Pattern numbers are incremented and decremented using
the “+” and “–” keys. Patterns that do not exist are skipped
and displayed in turn.
Pattern settings
Pattern
3015
Set button: Its lamp lights during the setting process. When [Enter] is pressed, it flashes for two seconds and then
goes off.
When the setting is in progress, Event is displayed in reverse video, and the event is then entered using [Enter]. Event
numbers can be incremented and decremented using the “+” and “–” keys. Empty events are indicated by [E] appearing next
to the event number.
Recall method
Press the [Recall] button, select the event number to be loaded using the number keys, and recall it using the [Enter] or
[AutoTake] button.
Recall button: Its lamp flashes while recall is underway. It lights when the button is set to ON, and goes off when it is set
to OFF or when the recall is completed.
Since the input settings are not reflected during loading, events are executed in respect of the input set beforehand.
Events 50 to 59, 60 to 69, 70 to 79, 80 to 89 and 90 to 99 can be set consecutively in units of 10 events and also recalled
consecutively so they can also serve as key frame settings. Events are executed using the [AutoTake] button. With the
recall of events 50 to 99, the Setup status of the head event is valid.
Clearing events
Set the number of the event to be cleared using [Recall], and execute clearing using [Shift] + [Enter]. Clearing all the events
is possible by inputting a period twice at the recall stage and then pressing [Shift] + [.]. Alternatively, this can be achieved by
starting the system by pressing [Shift] + [Enter] when the power is turned on, and restoring the factory settings.