77
Before use
AG-MX70 connections
It is necessary to connect the PC to the AG-MX70 using the
USB cable before installing the software. Follow the steps
below.
1) Turn off the power to the AG-MX70.
2) Connect the PC to the AG-MX70 using the USB
cable.
Insert the USB cable connectors into the
corresponding USB ports on the PC and on the rear
panel of the AG-MX70.
This completes the connection. When the 2 units are being
connected for the first time, install the USB driver by
following the steps in “Installation of USB driver” below.
<Note>
The USB cable is not supplied with this unit. Use a
commercially available 3 m or shorter USB cable. Note that
if the cable to be used is more than 3 m in length,
communications may not be performed correctly.
Installation of the USB driver
It is necessary to install this driver in the PC to enable USB
communications between the PC and AG-MX70 after they
are connected for the first time. (It is only necessary to
install the USB driver software once.) Follow the steps
below.
∫ For Windows 98 and Windows 2000
<Notes>
≥ The steps outlined below are for Windows 98.With
Windows 2000, the screens will differ slightly, but the
driver software can still be installed following the same
steps.
≥ Be sure to log on as a user with Administrator rights when
installing this software in a PC with Windows 2000.
1) Connect the PC to the AG-MX70 correctly.
2) Turn on the power to the PC.
Check that Windows has started up.
3) Place the setup CD-ROM in the PC’s CD-ROM drive.
4) Turn on the power to the AG-MX70.
After a short while, the “Add New Hardware Wizard”
dialog will be displayed.
5) Click on the “Next” button.
6) Select “Search for the best driver for your device,”
then click on the “Next” button.
8) If the driver is searched correctly, a screen similar to
the one shown below will be displayed.
9) When the screen indicating that the installation is
complete is displayed, click on the “Finish” button.
7) Place a check next to “Specify a location,” enter the
USB_DRV folder in the setup CD-ROM as the search
location and click on the “Next” button.