32
Effect-by-effect setting screens
[Pattern Edge] setting
This is used to set edges for the patterns. The border color
set here is used as the border matte for trail. It is updated
by the color which is read out for the direct pattern.
Select [Hard], [Soft], [Border] or [Soft Border] using the
rotary 2 control. The default setting is [Hard].
When [Soft] or [Soft Border] has been selected, No.2001 to
2195 and 6008 to 6010 patterns cannot be selected.
When [Soft Border] has been selected, the #701 to No.707
(24 to 27), 801 to 814 (183 to 196) patterns cannot be
selected.
The [Width] thickness can be set to any value from 1 to 255
using the rotary 3 control. The default setting is 32. Only 1
or 2 can be set for [Width] if any of the following patterns
have been selected:
≥ No.701 to 707 (24 to 27), 801 to 814 (183 to 196)
Select the [Color] border color using the rotary 4 control.
[White], [Yellow], [Cyan], [Green], [Magenta], [Red], [Blue],
[Black], [Custom1] or [Custom2] can be selected. Custom1
and Custom2 are colors which have been set by INT Matte.
Pattern
Edge Hard
Color
White
Hard
Soft
Border
Soft Border
1 - 255
White
Yellow
Cyan
Green
Magenta
Red
Blue
Black
Custom1
Custom2
Width
32
R1 R2 R3 R4 R5
<Note>
When the PinP pattern has been selected and STILL is executed through B bus, the edge cannot be reflected.