54
R1 R2 R3 R4 R5
[Setup] initial setting screen
[Audio Video Input] settings
These are used to set the audio and video inputs.
When [Setup] is selected using the rotary 2 control and
[Enter] is pressed, [OK?] appears so press [Enter] to change
to the setting mode. Use [Shift] + [Enter] to cancel.
When [Default] is selected using the rotary 2 control and
[Enter] is pressed, [OK?] appears so press [Enter] to change
to the default setting.
When [V-Link] is selected using the rotary 2 control and
[Enter] is pressed, [OK?] appears so press [Enter] to change
operation so that the audio input is matched with the video
input.
Factory settings
Audio
Video
Input
Setup
Setup
Default
V-Link
Event ME Time Pattern INT
00E 10:00F 3015 Wht
Audio Video Input Setup Enter to EXIT
1 V S-1 Video A S-1 Analog
2 V S-2 Video A S-2 Analog
3 V S-3 Video A S-3 Analog
4 V S-4 Video A S-4 Analog
5 V S-5 Video A S-1 Analog
6 V S-6 Video A S-2 Analog
7 V S-7 Video A S-3 Analog
8 V S-8 Video A S-4 Analog
AUXin Mic
Video
YC
Y Pb Pr
SDI
V S-1
V S-2
V S-3
V S-4
V S-5
V S-6
V S-7
V S-8
Mic
AUX2
Analog
SDI
A S-1
A S-2
A S-3
A S-4
Setting method
Press the button of the cross point to be set. Alternatively, select the button of the cross point which is to be set using the
rotary 1 control. The lamp of the selected button flashes, and the bus is automatically output to Preview. When the cross
point has been selected using the rotary 1 control, the A bus is output to Preview.
Select V S-1, V S-2, V S-3, V S-4, V S-5, V S-6, V S-7 or V S-8 as the video input using the rotary 2 control.
Select [Video] composite, [YC], [Y Pb Pr] component or [SDI] using the rotary 3 control.
Except for [Video], the sources extend from S-1 to S-4 so [5] is changed to [1], [6] to [2], [7] to [3] and [8] to [4]. If the setting
operation is exited part of the way through, the settings performed so far will not be stored in the memory. They are entered
using [Enter], and operation returns to the [Audio Video Input] settings.
Select A S-1, A S-2, A S-3 or A S-4 as the audio input using the rotary 4 control.
Select [ANALOG] or [SDI] using the rotary 5 control.
Video input combinations that cannot be set: S-5 to S-8 + YC/Y Pb Pr/SDI
Audio input combinations that cannot be set: Combination of SDIs with different source numbers
Example: SDI of S-1 for video and SDI of S-2 for audio
[Mic] or [AUX2] can be set for [AUXin] using the rotary 4 control. The default setting is [Mic].
R1 R2 R3 R4 R5