Filter
Top Products
131
MIXER Chapter 8 Parameter Guide
Chapter 8
Chapter 8 Parameter Guide
MIXER
The mixer allows you to combine Channel A and Channel B
together, adjust their relative levels and panning, and apply effects
and EQ to the combined signals.
MIXER A, B (MIXER CHANNEL A, B)
V-BASS LEVEL
TOTAL EQ (Total Equalizer)
This adjusts the tone of the mixed signals from Channel A and
Channel B. Parametric EQ is used for the low-middle and high-
middle frequency ranges.
MIXER
Parameter/
Range
Explanation
MIX SW (Mixer Switch)
OFF, ON
This setting switches mixing of Channel A
(or Channel B) on and off. The sounds in the
respective channel are not mixed when this
is set to OFF.
PAN
L100:0R–L0:100R
This sets the panning for Channel A (or
Channel B).
LEVEL
0–100
This sets the Channel A (or Channel B) vol-
ume level.
DELAY A SEND, DELAY B SEND
0–100
Adjusts the send level from Channel A (or
Channel B) to the mixer’s delay.
REVERB A SEND, REVERB B SEND
0–100
Adjusts the send level from Channel A (or
Channel B) to the mixer’s reverb.
CH DELAY (Channel Delay)
0–50ms Adjusts the time that the overall sound in
Channel A (or B) is delayed.
Although this is normally set to 0 ms, you
can produce greater breadth along with a
chorus effect by setting a difference in the
time the sounds are played relative to the
sounds from Channel B.
Parameter/
Range
Explanation
A/B BAL (A/B Balance)
A0:100B–A100:0B
Adjusts the volume balance of Channel A
and Channel B. You can set this parameter
in the Mixer screen or with the BALANCE
knob.
This parameter is disabled when DYNAM-
IC is on.
V-BASS LEVEL
0–200
Adjusts the overall patch volume.
Parameter/
Range
Explanation
EQ SW (Equalizer Switch)
OFF, ON
Turns the EQ effect on/off.
TOTAL GAIN
-12–+12dB
Adjusts the volume before the equalizer.
LOW GAIN
-12–+12dB
Adjusts the low frequency range tone.
HIGH GAIN
-12–+12dB
Adjusts the high frequency range tone.
LOW MID FREQ (Low Middle Frequency)
20Hz–10.0kHz
Specifies the center of the frequency range
that will be adjusted by the LOW MID
GAIN.
LOW MID Q (Low Middle Q)
0.5–16
Adjusts the width of the area affected by the
EQ centered at the LOW MID FREQ.
Higher values will narrow the area.
LOW MID GAIN (Low Middle Gain)
-12–+12dB Adjusts the low-middle frequency range
tone.
HIGH MID FREQ (High Middle Frequency)
20Hz–10.0kHz
Specifies the center of the frequency range that
will be adjusted by the HIGH MID GAIN.
HIGH MID Q (High Middle Q)
0.5–16
Adjusts the width of the area affected by the
EQ centered at the HIGH MID FREQ.
Higher values will narrow the area.
HIGH MID GAIN (High Middle Gain)
-12–+12dB
Adjusts the high-middle frequency range tone.
VB-99_e.book 131 ページ ２００８年８月１８日 月曜日 午後１時１０分