Filter
Top Products
79
Chapter 7 Other Functions
Chapter 7
The following section describes the parameters you
can set on each page.
* The screen shown in the example is for ASSIGN1.
Page 1, 3
F1: SOURCE (ASSIGN1–16 only)
This selects the controller assigned to the function.
F3: SW (ON/OFF)
Setting this to ON enables the controller.
F4–F6: TARGET PARAMETER
Use these to select the parameter you want to assign.
You can quickly locate and select the desired parameter by first
narrowing down the parameter type with F4, then using F5 and
then F6 to reach the right parameter.
For more details on the parameters, refer to
“CONTROL
ASSIGN”
(p. 135).
Page 2, 4
F2: MIN
This sets the minimum value for the target’s controllable range.
F3: MAX
This sets the maximum value for the target’s controllable range.
F4: SW MODE (only when a switch type controller is selected for
SOURCE)
This specifies how the switches function.
F4: MODE (GK S1, S2 only)
This specifies how the switches function.
* Combinations of the actions below are possible.
S1: DEC / S2: INC
S1: INC / S2: DEC
S1: MIN / S2: MAX
S1: MAX / S2: MIN
F5: RANGE LOW (only when an expression pedal or other controller
that changes values in a continuous, non-discrete way is set as
the source)
This sets the minimum for the range in which the value of the
setting can be changed.
F6: RANGE HIGH (only when an expression pedal or other
controller that changes values in a continuous, non-discrete way
is set as the source)
This sets the maximum for the range in which the value of the
setting can be changed.
Available Settings
Explanation
MOMENT
The parameter switches to the maximum
value only while the switch is held down,
and switches to the minimum value when
the switch is released.
LATCH
The value alternately switches between
maximum and minimum each time the
switch is pressed.
Available Settings
Explanation
INC
The value increases.
DEC
The value decreases.
MIN
The value is set to the minimum.
MAX
The value is set to the maximum.
VB-99_e.book 79 ページ ２００８年８月１８日 月曜日 午後１時１０分