Filter
Top Products
31
Chapter 2 Creating Sounds
Chapter 2
1.
Press [CHAIN].
2.
Use [F2] ( SEL) and [F3] (SEL ) to
select the arrow that indicates the connection
location for the COSM bass or normal pickup
sound.
3.
Use [F4] ( MOVE) and [F5] (MOVE ) to
move the connection location for the COSM
bass or normal pickup sound.
4.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If you do not need to save the settings, press [EXIT] to return to the
Play screen.
For a detailed block diagram of the signal path, refer to
“Signal Flow”
(p. 15).
1.
Press [MIXER].
2.
Press PAGE [ ] to display Page 1.
Make the settings for each channel on this page.
* Page 2 and later pages contain the mixer section’s common settings.
3.
Set the volume and panning with [F1]–[F6] or
with the F1–F6 knobs.
4.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the settings, press [EXIT] to return to the Play screen.
When mixing two channels, you can produce a more
realistic twin bass tone by setting a channel delay in one
of the channels, thus causing the two bass sounds to be
output at different times.
For detailed information on all the parameters, refer to
“MIXER”
(p. 131).
Setting the Connection Locations
for COSM Bass/Normal Pickup
Sound
Mixing Channels A and B
Together (MIXER)
Setting the Volume and Panning
for Each Channel
VB-99_e.book 31 ページ ２００８年８月１８日 月曜日 午後１時１０分