Filter
Top Products
81
Chapter 7 Other Functions
Chapter 7
The VB-99 features a function called Internal Pedal system. This
function assigns specified parameters to a virtual expression pedal
(the internal pedal), providing an effect automatically that changes
volume and tone in real time just the way an expression pedal
functions.
The Internal Pedal system features the following two functions,
allowing you to set Source for each assign 1-16 (p. 78) of the Control
Assign (p. 77).
• Internal Pedal
• Wave Pedal
* When the Internal Pedal or the Wave Pedal is used, set the ASSIGN
SW MODE to MOMENT.
Internal Pedal
With the trigger you have set, the assumed expression pedal starts
working. If you have set INTERNAL PEDAL to SOURCE, set the
TRIGGR parameter (p. 141).
For more detailed information on the parameters that can be set
using INTERNAL PEDAL, refer to
“TRIGGR (Trigger)”
(p.
141),
“TIME”
(p. 141), and
“CURVE”
(p. 141).
Wave Pedal
This changes the parameter selected as a target in a certain cycle with
the assumed expression pedal. When you have set WAVE PEDAL
for SOURCE, the RATE parameter (p. 141) and FORM parameter (p.
141) should be set.
For more detailed information on the parameters that can be set
using WAVE PEDAL, refer to
“RATE”
(p. 141) and
“FORM”
(p.
141).
You can assign your favorite patches to the [DIRECT PATCH 1] –
[DIRECT PATCH 5] buttons, then call up these patches just by
pressing the buttons.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to go to Page 1.
3.
Press [F2] (DIRECT).
The DIRECT PATCH screen appears.
4.
Use the F1–F5 knobs to select the patches to
be assigned to [DIRECT PATCH 1]–
[DIRECT PATCH 5].
The numbers correspond, with DIR. PATCH 1 assigned with
the F1 knob, DIR. PATCH 2 assigned with the F2 knob, and so
on.
5.
Press [EXIT] several times to return to the Play
screen.
Activating the Virtual Expression
Pedal at the Start of Operations
(Internal Pedal System)
One Touch Call Up of Favorite
Patches (DIRECT PATCH)
Setting DIRECT PATCH
VB-99_e.book 81 ページ ２００８年８月１８日 月曜日 午後１時１０分