Filter
Top Products
66
Chapter 6 Using the VB-99 Connected to a Computer Via USB
1.
Press [SYSTEM].
2.
Press PAGE [ ] [ ] to go to Page 2.
3.
Press [F2] (USB).
4.
Press PAGE [ ] to go to Page 2.
5.
Set the DRIVER MODE with [F1] (SELECT) or
the F1 knob.
* When using VB-99 Editor/Librarian, set this to ADVANC.
* The message “PLEASE RESTART” appears when DRIVER
MODE is switched.
6.
Press [EXIT] one or more times to return to the
Play screen.
* If you have not yet installed the driver for the mode you have set,
turn off the power to the VB-99 in this condition and install the
driver.
7.
Quit all sequencer software and other
applications on the computer that are using
the VB-99.
8.
Turn on the power to the VB-99 again.
* The functions of a mode won’t become available until after the power
has been turned off, then on again.
About MIDI in Standard Driver Mode
You cannot use MIDI when STNDRD is selected as the driver mode.
If you want to use MIDI with the USB connection, set the VB-99 to
the advanced driver mode.
The following section describes the VB-99’s USB-related functions.
Make these settings in accordance with how you plan to use the VB-
99.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to go to Page 2.
3.
Press [F2] (USB).
4.
Press PAGE [ ] to go to Page 1.
5.
Change the setting’s value with [F1]–[F4] or
the F1–F4 knobs.
6.
Press [EXIT] one or more times to return to the
Play screen.
Switching the Driver Mode
Setting Explanation
STNDRD
This mode uses the OS’s standard USB driv-
er.
ADVANC
This mode uses the dedicated driver con-
tained on the CD-ROM.
Setting the USB Functions
Setting the Digital Audio Signal
Input and Output
Parameter/
Range
Explanation
USB IN
This sets the point at which digital audio signals received via USB
(from your computer) are connected within the VB-99.
* Do not connect at a point before the point set with the USB OUT
parameter. For more on the connection points, refer to
“Signal Flow”
(p. 15).
* If the USB IN parameter is set to COSM BASS A, COSM BASS B, or
NORMAL PU, the setting automatically changes to MAIN & SUB the
next time the VB-99 is powered up. If you plan to use COSM BASS A,
COSM BASS B, or NORMAL PU, make the setting each time you
turn on the power to the VB-99.
OFF
The signals are not connected at any point.
COSM BASS A The signals are connected at the point where
the COSM BASS A is output.
The audio output from the computer, in-
stead of the COSM bass sounds played by
the connected bass, is input to the effects.
* POLY FX are not applied.
VB-99_e.book 66 ページ ２００８年８月１８日 月曜日 午後１時１０分