Roland LX-10 Electronic Keyboard User Manual


 
12
Important Notes
Additional Precautions
551
Please be aware that the contents of memory can be
irretrievably lost as a result of a malfunction, or the improper
operation of the unit. To protect yourself against the risk of
loosing important data, we recommend that you periodically
save a backup copy of important data you have stored in the
unit’s memory on a USB memory.
552
Unfortunately, it may be impossible to restore the contents of
data that was stored on a internal memory or a USB memory
once it has been lost. Roland Corporation assumes no liability
concerning such loss of data.
553
Use a reasonable amount of care when using the unit’s
buttons, sliders, or other controls; and when using its jacks
and connectors. Rough handling can lead to malfunctions.
554
Never strike or apply strong pressure to the display.
555
A small amount of noise may be heard from the display during
normal operation.
556
When connecting / disconnecting all cables, grasp the
connector itself—never pull on the cable. This way you will
avoid causing shorts, or damage to the cable’s internal
elements.
557
A small amount of heat will radiate from the unit during
normal operation.
558a
To avoid disturbing your neighbors, try to keep the unit’s
volume at reasonable levels. You may prefer to use
headphones, so you do not need to be concerned about those
around you (especially when it is late at night).
559b
When you need to transport the unit, pack it in shock-
absorbent material. Transporting the unit without doing so
can cause it to become scratched or damaged, and could lead
to malfunction.
560
Do not apply undue force to the music stand while it is in use.
562
Some connection cables contain resistors. Do not use cables
that incorporate resistors for connecting to this unit. The use
of such cables can cause the sound level to be extremely low,
or impossible to hear. For information on cable specifications,
contact the manufacturer of the cable.
565
Before opening or closing the keyboard lid, always make sure
that no pets or other small animals are located on top of the
instrument (in particular, they should be kept away from the
keyboard and its lid). Otherwise, due to the structural design
of this instrument, small pets or other animals could end up
getting trapped inside it. If such a situation is encountered,
you must immediately switch off the power and disconnect
the power cord from the outlet. You should then consult with
the retailer from whom the instrument was purchased, or
contact the nearest Roland Service Center.
Add
The horizontal bars that connect the main unit to the bottom
of the front legs are quite strong; however for safety’s sake,
please do not allow children to get on them.
Floppy Disk Handling
(Using Optional Floppy Disk Drive)
651
Floppy disks contain a plastic disk with a thin coating of
magnetic storage medium. Microscopic precision is required
to enable storage of large amounts of data on such a small
surface area. To preserve their integrity, please observe the
following when handling floppy disks:
Never touch the magnetic medium inside the disk.
Do not use or store floppy disks in dirty or dusty areas.
Do not subject floppy disks to temperature extremes (e.g.,
direct sunlight in an enclosed vehicle). Recommended
temperature range: 10–50 degrees C (50–122 degrees F).
Do not expose floppy disks to strong magnetic fields, such
as those generated by loudspeakers.
652
Floppy disks have a “write protect” tab which can protect the
disk from accidental erasure. It is recommended that the tab
be kept in the PROTECT position, and moved to the WRITE
position only when you wish to write new data onto the disk.
fig.DiskProtect.e.eps
653
The identification label should be firmly affixed to the disk.
Should the label come loose while the disk is in the drive, it
may be difficult to remove the disk.
654
Store all disks in a safe place to avoid damaging them, and to
protect them from dust, dirt, and other hazards. By using a
dirty or dust-ridden disk, you risk damaging the disk, as well as
causing the disk drive to malfunction.
Rear side of the disk
Write
(can write new data onto disk)
Protect
(prevents writing to disk)
Write Protect Tab
LX-10_e.book 12 ページ 2008年9月22日 月曜日 午前10時51分