Filter
Top Products
90
Various Settings
The settings you’ve changed in Function mode can be restored
to their factory-set condition. This operation is called “Factory
Reset.”
Execute this operation if you want the settings you’ve stored
using Memory Backup to be returned to their original state.
When you execute “Factory Reset,” all settings you’ve
stored up to that point will be cleared, and reset to
their factory-set condition.
Executing this operation will not erase the songs from
internal memory or USB memory.
If you want to erase all songs from the LX-10‘s internal
memory and all songs from USB memory, refer to
“Initializing the Memory” (p. 70).
1.
Hold down the [Effects] button and press the
[3D] button.
The LX-10 will enter Function mode.
2.
Use the [
▲
] [
▼
] buttons to select “Factory
Reset.”
fig.d-FuncMenu-Reset.eps
3.
Press the [ ] button.
The following appears in the display.
fig.d-Reset.eps
If you decide to cancel without executing, press the [Piano
Designer] button.
4.
If you’re sure you want to execute Factory
Reset, press [ ].
A confirmation message appears in the screen.
fig.d-Reset2.eps
5.
Press the [ ] button.
If you decide to cancel without executing, press the
[ ] button.
When the Factory Reset is complete and the following
appears in the screen.
fig.d-Reset3.eps
6.
Turn the [Volume] knob all the way toward
the left to minimize the volume.
7.
Switch the power off, then back on.
Restoring the Settings to the Factory
Condition (Factory Reset)
NOTE
LX-10_e.book 90 ページ ２００８年９月２２日 月曜日 午前１０時５１分