Filter
Top Products
83
Song Mode
Recording a song
You can input patterns one by one to specify the order in which the
patterns will be played back.
Recording procedure
1.
Use [VALUE] or [INC/DEC] to select the song number
that you want to record.
2.
Press [REC].
fig.3-03
3.
Select the pattern to be played at this step.
Refer to
Selecting a pattern to play back
(p. 24)
4.
Press [ENTER].
You will proceed to the next step.
5.
Repeat the above steps 3 and 4 to input the patterns
to be played for the subsequent steps.
6.
After you have finished inputting the last step, press
[STOP] to end the recording process.
Auditioning a pattern
While you are recording, you can press [PLAY] to audition the
selected pattern. You can select different patterns while you audition
them. To stop the auditioning, press [STOP].
Moving between steps
After recording several steps, you can press [BWD] [FWD] to move
between steps.
Editing the setup parameters
During song recording, you can edit setup parameters (p. 26) such as
part mute and effect settings and then press [ENTER] to register the
state of those parameters. This will simply store the setup
parameters of each pattern as song data, and does not affect the
original pattern in any way.
By using this to change the mute status of a pattern or to change the
MFX type, you can have a single pattern play in a variety of ways as
the song progresses.
• Tempo (BPM) can be input/edited only at the first step.
• It is not possible to change the tempo during the song.
MC-909_Ref_e.book 83 ページ ２００５年３月１日 火曜日 午後３時２９分