Filter
Top Products
12
Mix 16 tracks down to 2 tracks (Mastering Room)
fig.2-03
3. Press [ENTER (YES)].
4. Use [ ], [ ], [ ], and [ ] to move the cursor
to “Status.”
fig.2-18
5. Select the “Status” of the mastering tracks. Rotate the
TIME/VALUE dial.
Status
Specify the status of the master tracks. For this example select
“Off.”
Off: The mastering tracks will not be used.
Rec: Play back tracks 1–16 and record on the mastering
tracks.
Play: Play back the mastering tracks. The sound of tracks
1–16 will not be output from the MASTER jacks.
MEMO
For details on the signal flow (routing) at this time, refer to
Signal flow (routing) (p. 13).
6. Use [ ], [ ], [ ], and [ ] to move the cursor
to “EFXIns.”
fig.2-19
7. Press [ENTER (YES)].
8. Use [ ], [ ], [ ], and [ ] to move the cursor.
Use the TIME/VALUE dial to make settings.
fig.2-20.e
EFX1 (effect insert switch 1)
Select how the effect will be connected.
Off: The effect will not be inserted.
Ins: The stereo effect will be inserted into both channels.
The inserted effects are shown as icons and as patch
names (up to ten characters).
Snd (effect send level)
Adjust the volume level of the signal that is sent to the
insertion effect (-42–6 dB). By default, this will be “0 dB.”
Rtn (effect return level)
Adjust the volume level of the signal that is output from the
insertion effect (-42–6 dB). By default, this will be “0 dB.”
9. Press [F1 (EFX1)].
10. Press [F2 (Sel)].
11. Use the TIME/VALUE dial to move the cursor to the
effect that you wish to use. For this example, select an
effect such as “P210 MTK:Mixdown.”
fig.2-21
12. After selecting an effect, press [F4 (Exec)].
13. Press [F6 (EXIT)].
Effect Insert Switch
Insert Send Level
Insert Return Level