Filter
Top Products
24
Editing an automix
fig.4-04.e
NOTE
Even if there is only one marker for the automix data that you wish
to increase or decrease, press the button in the order of [F1 (In)]
→
[F1 (Out)] at the same marker location.
MEMO
You can rotate the TIME/VALUE dial to modify the automix
setting value at the cursor location. If you wish to re-select
the automix data that will be edited, press [ ].
9. Press [F5 (Exp)].
10. Use [ ][ ][ ][ ] to move the cursor.
Operate the TIME/VALUE dial to set the parameters.
fig.4-24
Target
This will indicate the type of automix data whose data will
be increased or decreased, as you selected in step 6. If you
wish to shift or expand the values of all automix data, use the
TIME/VALUE dial to select “All Level and Pan.”
Shift
Specify the actual amount (-50–50) by which the automix
data values will be increased or decreased.
fig.4-25.e
Expand
Specify the ratio (0.5–2.0) by which the automix data values
will be increased or decreased relative to the “Threshold.”
Threshold
When using Expand to increase or decrease the automix data
values by a specified proportion, this specifies the center
value.
fig.4-26.e
11. To execute the Shift/Expand operation, press [F4 (Exec)].
If you press [F6 (EXIT)], you will return to step 7 without
executing the Shift/Expand operation.
12. A message will ask you to confirm. Press [YES]. If you
press [NO], you will return to step 11 without executing
the Shift/Expand operation.
fig.4-27_80
13. When the Shift/Expand operation has been completed,
the display will indicate “Complete.” Press
[PLAY (DISPLAY)].
Check marks
0M1 M8
Time
Shift
0M1 M8
Time
Expand
Threshold