Filter
Top Products
23
Editing an automix
fig.4-18.e
11. To execute the Gradation operation, press [F4 (Exec)]. If
you press [F6 (EXIT)], you will return to step 7 without
executing the Gradation operation.
12. A message will ask you to confirm the operation. Press
[YES]. If you press [NO], the Gradation operation will be
halted, and you will return to step 11.
fig.4-19
13. When the Gradation operation has been executed, the
display will indicate “Complete.” Press
[PLAY (DISPLAY)].
Increasing or decreasing all
data values (Shift/Expand)
This operation increases or decreases the values of the
automix data in a specific area. This can be done in two ways:
Shift adds (or subtracts) the same amount to each auto-mix
data value, and Expand increases or decreases all auto-mix
data values by the same proportion relative to a specified
standard value.
fig.4-20.e
NOTE
Editing of the automix data cannot be cancelled by the Undo
function (VS-1680 Owner’s Manual, p. 160).
1. Press [PLAY (DISPLAY)].
2. Hold down [SHIFT] and press [F6 (UTIL)].
3. Press [PAGE] so that [F5] indicates “A.Mix,” and then
press [F5 (A.Mix)].
fig.4-02
4. Press [F2 (Micro)].
5. Press [PAGE] so that [F1] indicates “In.”
fig.4-03
6. Make sure that the cursor is located at “Edit Target,” and
use the TIME/VALUE dial to select the automix data
that will be increased or decreased.
7. Use [ ][ ] to move the cursor to the first marker of
the automix data that you wish to increase or decrease,
and press [F1 (In)].
8. Use [ ][ ] to move the cursor to the last marker of
the automix value that you wish to increase or decrease,
and press [F1 (Out)]. Check marks will be added to the
selected area.
0M1 M5
Time
Gradation area
0M1 M8
Time
Gradation area
0M1 M8
Time
0M1 M8
Time
0M1 M8
Time
0M1 M8
Time
Shift
Expand