Filter
Top Products
28
Using the VS-1680 with a CD-R/CD-RW drive
+Verify
If this is turned “On,” verification will be performed to check
whether or not the data was saved correctly after the song
data has been backed up.
CD Speed
Select the speed at which the song data will be backed up to
the CD-RW disc
x2 (353 KBps): Backup at double speed (353 kilobytes per
second).
x1 (176 KBps): Backup at normal speed (176 kilobytes per
second). This will increase the reliability.
NOTE
Depending on the disc, it may not be possible to back up reliably to
a CD-R disc with a setting of “x2 (353 KBps).” In such cases,
select “x1 (176 KBps).” Also, if you insert a CD-RW disc into a
CD-RW drive, it will not be possible to select “x1 (176 KBps)”
(backup will occur at double speed).
7. If two or more drives are connected, you can press
[F5 (SelDr)] to see a list of the drives. After checking the
list of drives, press [F1 (Back)].
fig.5-09_70
8. Press [F4 (Exec)]. A message will ask you to confirm.
fig.5-10
9. Press [YES]. The display will ask “STORE Current?”
(store the current song?)
10. If you wish to save the current song, press [YES]. If not,
press [NO]. If a protected song (such as a demo song) is
selected, press [NO].
11. If the amount of song data is too large to back up onto a
single CD-RW disc, the CD-RW disc will be ejected, and
you will be prompted to “Insert Disc #” (where # is
number of each disc in the series), so that the VS-1680 can
verify the number of discs that will be required. Insert
the next CD-RW disc, and press [YES]. At this time, we
recommend that you use a soft-tipped felt marker pen to
write the disc number on the disc label so that you can
remember the sequence in which each disc should be
inserted.
fig.5-11
12. If the backup extends over two or more discs, the display
will prompt you to “Insert Disc #.” Insert each disc once
again in the correct sequence, and press [YES]. Then,
backup will begin.
13. When the CD-R backup ends, you are returned to Play
condition.
Restoring songs from a
CD-RW disc (Recover)
Specifying the speed of
recovery (Speed)
Now you can specify the speed at which the data will be read
when recovering a song from a CD-RW disc.
Recovery procedure
1. Select the loading destination (recovery destination)
drive as the current drive.
2. Insert the CD-RW disc that contains the song backup into
the drive.
3. Press [PLAY (DISPLAY)].
4. Hold down [SHIFT] and press [F6 (UTILITY)].