Filter
Top Products
15
New effects algorithms
BCut (Bass-cut filter)
This removes unwanted low-frequency components, such as
pop noise.
Sw (Switch) Off, On
Turns the bass-cut filter on/off.
Freq (Frequency) Thru, 20–2,000Hz
Adjusts the cutoff frequency of the bass-cut filter.
Enh (Enhancer)
This effect adds a phase-shifted signal to the original signal,
enhancing the presence of the sound, and bringing it to the
foreground.
Sw (Switch) Off, On
Turns the enhancer on/off.
Sens (Sensitivity) 0–100
Adjusts the degree to which the enhancer will respond to the
volume of the input signal.
Freq (Frequency) 1.0–10.0kHz
Adjusts the frequency at which the enhancer will begin to
take effect. The effect is applied at frequencies above the
specified value.
MixLvl (Mix level) -24–+12dB
Adjusts the amount of effect sound that will be added to the
original sound.
In (Input)
The input signal is divided into three parts by frequency
band.
InputG (Input gain) -24–+12dB
Adjusts the overall volume level of the signal before it enters
the expander (Exp) and compressor (Cmp).
D-Time (Detect time) 0–10ms
If the original signal is slightly delayed before being input,
the expander/compressor will be able to use more
processing time, and can adjust the level more appropriately.
Adjusts the time by which the original signal is delayed.
The output signal from the Mastering Tool Kit is delayed by
the time set here.
L-SplitP (Low split point) 20–800Hz
H-SplitP (High split point) 1.6–16kHz
Specify the frequencies at which the original signal will be
split into three parts.
fig.3-04
Exp (Expander)
This effect restricts the output by a specific ratio when low-
level signals are input.
fig.3-05
Sw (Switch) Off, On
Turns the expander on/off.
Low Thre (Low threshold) -80–0dB
Mid Thre (Middle threshold) -80–0dB
High Thre (High threshold) -80–0dB
Specify the level at which the expander will begin to take
effect.
Low Ratio 1:1–1:16, 1:INF
Mid Ratio 1:1–1:16, 1:INF
High Ratio 1:1–1:16, 1:INF
Adjust the ratio by which the output is restricted when the
input level is below the threshold level.
Low Atck (Low attack) 0–100ms
Mid Atck (Middle attack) 0–100ms
High Atck (High attack) 0–100ms
Adjust the time from when the input level falls below the
threshold level until the expander begins to take effect.
Low Rel (Low release) 50–5,000ms
Mid Rel (Middle release) 50–5,000ms
High Rel (High release) 50–5,000ms
Adjust the time from when the input level exceeds the
threshold level until the expander effect is bypassed.
Freq
L-SplitP H-SplitPLevel
Low Mid High
ThresholdOut
In1:1
Ratio
1:2