Filter
Top Products
41
Enhancements to the display and specifications
3. Press [F4 (Exec)]. Alternatively, press [PAGE] so that [F4]
indicates “Exec,” and then press [F4 (Exec)].
fig.7-09
4. Press [F4 (Exec)] once again.
5. A message will ask for confirmation. Press [YES]. The
mastering template will be recalled. To cancel, press
[NO].
fig.7-10
At this time, the main settings will be as follows.
Inputs 1–8 :Master out
Tracks 1–15/16 :Playback
Mastering tracks :Off
Effect 1 :Mastering tool kit (insert)
6. You are returned to Play condition.
MEMO
If you wish to modify the mastering template, refer to
“Storing Routings as a Single List (Template)” (VS-1680
Owner’s Manual, p. 41).
Immediate application of
step-edited changes
Changes you make to Easy Routing settings by step-editing
(recording, mixdown, bouncing) will now be applied
immediately to the actual routing.
For example if you raise or lower the level of a channel by
step editing, the volume will now change accordingly. The
same is true for pan, output destination, effects or AUX
levels. This lets you hear the actual result while you set the
routing.
MEMO
Previously, you were asked “Apply this Routing?” when you
had completed your routing settings, and the routing
settings you made were actually applied only when you then
pressed [YES].
Settings not stored in a
scene (Monitor Level)
Monitor level (the location of the MONITOR knob) is no
longer stored in a scene. Even when you recall a stored scene,
the monitor level will be determined by the current position
of the MONITOR knob.
fig.7-11
Master Send switch display
has been changed
(Pan→MIX)
The Master Send switch display has been changed from
“Pan” to “MIX.” When reading the previous Owner’s
Manual (including Quick Start and Appendices), please read
any reference to [F1 (Pan)] as [F1 (MIX)].
fig.7-12