Filter
Top Products
27
Using the VS-1680 with a CD-R/CD-RW drive
9. Press [F4 (Exec)].
10. Press [YES]. A message about the license agreement will
appear. Read the message carefully, and if you consent to
that, press [YES]. The data will begin to write to the CD-
R disc. If you do not consent, press [NO]. You will return
to step 2.
fig.5-06
MEMO
The message about the license agreement is the same as
“About the License Agreement” on the back cover of the
“VS-1680 Owner’s Manual.”
11. When the data has been written successfully, the display
will ask “Write Another ?” (write to another disc?). If you
wish to write the identical song data to another CD-R
disc, insert the new disc into the CD-RW drive, and press
[YES]. If you press [NO], you will return to step 2.
Saving a song to a CD-RW
disc (Backup)
Checking whether the song
was saved correctly
(+Verify)
After backing up a song to a CD-RW disc, you can now check
whether or not the data was saved correctly (i.e., check the
recorded state of the data).
If as a result of the +Verify operation, you are warned that
the song data has not been saved correctly, you should back
up to a different disc.
NOTE
When backing up to a CD-R, we recommend that you use +Verify
to check whether the backup was performed correctly. However,
+Verify checks the entire surface of the disc, so it takes a
considerable amount of time.
Specifying the speed of
saving (Speed)
When backing up a song on a CD-RW disc, you can now
specify the speed at which the data will be written.
Backup procedure
1. As the current drive, select the drive (internal IDE hard
disk) that contains the song you wish to back up.
2. Insert a CD-RW disc into the drive.
3. Press [PLAY (DISPLAY)].
4. Hold down [SHIFT] and [F6 (UTILITY)].
5. Press [F2 (CDRBk)]. If [F2] does not indicate “CDRBk,”
first press [PAGE] so that “CDRBk” is displayed, and
then press [F2 (CDRBk)].
fig.5-07
6. Use [ ][ ][ ][ ] to move the cursor, and
rotate the TIME/VALUE dial to set the parameters.
fig.5-08
Source Song
The marked songs will be backed up. Move the cursor to a
song that you wish to back up, and press [F3 (MARK)]. By
pressing [F2 (ALL)] you can mark or unmark all songs at
once. By pressing [F1 (SelSg)] you can view a list of the
songs. At this time, mark a song and press [F1 (Back)].