Filter
Top Products
11
When you press the knob and
release it instantly:
When you press the knob and
release it instantly, the sound or
signal continues to be output.
When you press the knob and
release it again, output ceases.
3 LCD (Liquid Crystal Display)
What is displayed depends on the
setting of the FUNCTION switch.
For detailed information, see “4
FUNCTION switch.”
A heater is built into the LCD to be
used in cold weather. This prevents
the LCD from slowing down the
display speed. The temperature is
detected and the heater is
automatically turned on or off.
Note
This heater is activated only with an
external power supply. When the
power is supplied from the batteries,
the heater is not activated.
4 FUNCTION switch
LOCK: Set to this position to lock the
controls and switches on the front
panel to the settings at the time
you set the switch to the LOCK
position. Switches and controls
locked are the Input level control,
PAN control, LINK/M-S switch,
MASTER control and MASTER
LINK switch.
The PANEL LOCK sub menu of
the SETUP menu allows you to
decide which switches and controls
are to be locked or unlocked.
LCD in the lock mode: Displayed
in the display mode. You can
select the item to be displayed by
turning the ADJUST knob.
When you operate locked
switches or controls: The
following message is displayed to
state that the switch or control is
locked.
However, these switches and
controls activate with the current
settings when the FUNCTION
switch is set to the SETUP or
DISPLAY position.
When the power is turned off
with the lock setting in place:
Switches and controls are still
locked when you turn on the power
again.
SETUP: Set to this position to set
parameters.
DISPLAY: Set to this position to
display meters. The meter to be
displayed is changed in the
following sequence by turning the
ADJUST switch: Full size level
meter t Multi meter t Input
level meter for channels 1 and 2
t Input level meter for channels
3 and 4 t Information.
SLATE: Set to this position to use the
SLATE function. The SLATE
switch becomes activated. The
kind of the output signal depends
on the setting of 2 SLATE
switch.