Filter
Top Products
32
10. PANEL LOCK Sub-
Menu
When the FUNCTION switch is set to
LOCK, all of or some of the switches
and controls on the front panel are
locked and you cannot operate them.
This sub-menu allows you to decide
which switches and controls should be
locked, from among the input level
control, PAN control, LCF switch, L/
R MASTER output level control,
LINK/M-S switch, and MASTER
LINK control.
10. PANEL LOCK sub-menu
Turning the ADJUST knob to the right
changes the setting item in the following
sequence: IN VOL t PAN t LCF t
IN LINK t OUT VOL t OUT LINK.
Turning the ADJUST knob to the right
changes the selection in the following
sequence: LOCK t UNLOCK.
Default setting: LOCK
11. METER SELECT
Sub-Menu
This sub-menu allows you to select
the level meter to be displayed on the
LCD from among 6 types of meter,
VU, PPM1, PPM2, PPM3, PPM4 and
dBFS.
The dBFS meter is the default.
When you change the type of meter
displayed using this sub-menu, you
should replace the meter scale sheet
with the one corresponding to the new
meter.
For detailed information on the
supplied meter scale sheets, see
“Replacing a Meter Scale Sheet” on
page 41.
11. METER SELECT sub-menu
Turning the ADJUST knob to the right
changes the selection in the following
sequence: VU t PPM1 t PPM2 t
PPM3 t PPM4 t dBFS.
The type of the meter currently being
displayed is surrounded by parenthesis.
Note
The following table shows the
relationship between the meter
displayed on the LCD and the meter
type.
Settings from the Setup Menu