Filter
Top Products
43
Symptom
An impression of stereo
sound cannot be obtained.
even when an MS
microphone is used.
Sound is not output from the
R channels of the
headphones.
The sampling rate cannot
be switched.
The MASTER volume does
not activate to adjust the
level of the signal output
from the COAXIAL
connector.
Possible causes
The S side of the MS
microphone is connected to
channel 1 or channel 3, and
the M side is connected to
channel 2 or channel 4.
LINK/M-S is set to LINK on the
LINK/M-S sub-menu.
A monaural earphone is
connected to the other
PHONES connector.
The unit was not restarted
when the SAMPLING RATE
switch setting was changed.
The S/PDIF/CASCADE switch
is set to CASCADE.
Remedies
Connect the M side to channel
1 or 3 and the S side to
channel 2 or 4.
Change the LINK/M-S setting
to M-S on the LINK/M-S sub
menu.
Use stereo headphones or
earphones.
Restart the unit after you
change the sampling rate. The
setting of the SAMPLING
RATE switch is switched only
when the unit is restarted.
(page16)
Set the switch to S/PDIF. The
CASCADE function is used
only when two DMX-P01s are
connected in cascade. In this
case, the MASTER volume
control does not activate.
(page 16)